Special side car fender needs
Ken Hosford
Posted 7/10/2010 12:07 PM (#52413)
Subject: Special side car fender needs


Posts: 1
I am able to create Fenders of special radius and widths that my be needed for side car needs . I am an individual trying to make a go at this in a rotten economy . I make curved top not flat top fenders do to the process I use . I am able to make in steel , stainless , aluminum both smooth and diamond plate I have worked up .06" steel .045" stainless ,and .07" aluminum . Anodizing the aluminum should be far cheaper than paint These fender are made in Michigan the state of recession to ones individual needs , at what should be fair prices . To say it is a business is pushing it in the few I build would pay no rent or electricity let alone the cost of equipment ,tooling and material



(wide steel.jpg)



(aluminum diamond side.jpg)



Attachments
----------------
Attachments wide steel.jpg (1042KB - 45 downloads)
Attachments aluminum diamond side.jpg (158KB - 39 downloads)
Top of the page Bottom of the page
Hack'n
Posted 7/10/2010 1:07 PM (#52414 - in reply to #52413)
Subject: Re: Special side car fender needs



Posts: 4833
Location: Boise, Idaho
Have you fixed pricing for your fenders?

Lonnie
Top of the page Bottom of the page