Return to Home page

Search | Statistics | User Listing Forums | Calendars | Albums | Quotes
Sidecar.com Forum ->  General discussion -> Technical Discussion -> View Thread

You are logged in as a guest. ( logon | register )

Random quote: "If at first you don't succeed, buy another motorcycle"
- (Added by: DAVE)

need help with toe adjustments
Jump to page : 1
Now viewing page 1 [25 messages per page]
View previous thread :: View next thread
   General discussion -> Technical DiscussionMessage format
 
negpos
Posted 8/21/2015 11:29 AM (#85920)
Subject: need help with toe adjustments


Member

Posts: 11
0
I have a 70s harley sidecar and i need to make adjustments for the toe
I have looked over the manual and don't see it. Can someone here give
give me info on where the adjustments are located on the sidecar.
Top of the page Bottom of the page
Phelonius
Posted 8/21/2015 1:52 PM (#85922 - in reply to #85920)
Subject: Re: need help with toe adjustments



Elite Veteran

Posts: 725
50010010025
Location: N.lat 20- 13' -58" W.lon 155 - 48' - 31"
Find a straight line on your garage floor. Maybe a seam in the concrete, maybe snap a chalk line.
Line the bike wheels up on the line so that the center of each tire is on the line. bungee a long straight edge to the sidecar wheel. Make sure the bike is vertical.
Measure from the straight edge to the line at the front of the front wheel and at the rear of the rear wheel.
use the sliding joints or threaded shafts that join the lower attachment points to the bike to adjust so that the front measure is about 3/4 inch less than the rear measure.
The upper struts should be disconnected when you do this.
Now lean the bike about one degree away from the sidecar and lock every thing in place.
This is a good starting point to work from. Test ride the machine to check for pull to one side or the other. Adjust until at 55 mph or your most often used speed, there is no side pull.
Adjust in small amounts doing the upper mounts until it is where you want it. Watch for tire wear on the sidecar tire over the next 500 miles.
If wear is excessive you may have to adjust the toe in again.
Top of the page Bottom of the page
jaydmc
Posted 8/21/2015 4:43 PM (#85924 - in reply to #85920)
Subject: Re: need help with toe adjustments


Expert

Posts: 1513
1000500
On most bikes you would compress the bike suspension before setting up the lean out. Harley does not tell you to do this so instead they have you lean the bike in, then when you sit on the bike it ends up leaned out. I have attached generic alignment information.
Jay G
DMC sidecars
www.dmcsidecars.com
866-638-1793



Attachments
----------------
Attachments BASIC SIDECAR INSTRUCTIONS.doc (388KB - 40 downloads)
Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [25 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

 


Copyright 2004-2008, The United Sidecar Association — Built by BarringtonPress — Send your suggestions and comments to the webmaster
USCA Web usage policy



(Delete all cookies set by this site)
Running MegaBBS ASP Forum Software
© 2002-2017 PD9 Software