Return to Home page

Search | Statistics | User Listing Forums | Calendars | Albums | Quotes
Sidecar.com Forum ->  General discussion -> General Discussion -> View Thread

You are logged in as a guest. ( logon | register )

Random quote: "The past isn't dead; it isn't even past." Faulkner
- (Added by: pssstpok)

Will this work?
Jump to page : 1
Now viewing page 1 [25 messages per page]
View previous thread :: View next thread
   General discussion -> General DiscussionMessage format
 
Red Ryder
Posted 2/8/2017 9:03 PM (#92299)
Subject: Will this work?


Member

Posts: 33
25
Location: West Branch, Michigan
Hey, last fall had the CSC III and 08 Harley Ultra dialed in the best I could with the parts I had. But, the only way it would work is reversed the Bosses. Problem is the axle to axle was 15 1/2", which caused right turns to be a workout.
So, detached it, to see what parts I will need. Brought csc back to 10", put clamps & bosses on. Now the angles changed, there is No way the lower 45 clamp is ever going to work even with a longer or different Boss. Angle is too severe and won't come close to mount.
So, switched clamps around, the lower front is going to need a longer 45 degree boss, and in lower rear used the 70 degree solid metal boss, which worked.

Question--Does it really matter which clamps & boss mounts together as long as there is No Movement? Thanks for any replies-
Top of the page Bottom of the page
jaydmc
Posted 2/9/2017 10:13 AM (#92302 - in reply to #92299)
Subject: Re: Will this work?


Expert

Posts: 1513
1000500
You should keep 45 degree bosses with 45 degree clamps and 70 degree bosses with 70 degree clamps, in other words do not mix them. It does not matter which you run, we find more often that two 70 degree clamps and bosses work much better then a 45 and a 70. We also offer the 70 degree bosses extra long with a double walled tubing in order to reach a greater distance fore and aft. And we offer then with a longer end in order to help get under the floor board. Usually we have these in stock ready to ship the same day. And of course we can custom make you what ever you need for your application.
Jay G
DMC sidecars
www.dmcsidecars.com
866-638-1793
Top of the page Bottom of the page
Red Ryder
Posted 2/9/2017 2:42 PM (#92304 - in reply to #92299)
Subject: Re: Will this work?


Member

Posts: 33
25
Location: West Branch, Michigan
Thanks Jay, will get with you for parts. Later-
Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [25 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

 


Copyright 2004-2008, The United Sidecar Association — Built by BarringtonPress — Send your suggestions and comments to the webmaster
USCA Web usage policy



(Delete all cookies set by this site)
Running MegaBBS ASP Forum Software
© 2002-2017 PD9 Software